ConLab Volt AC Transmitter Sensor
ConLab Volt AC Transmitter Sensor
Overview
The AC Voltage transmitter is a self-powered transformer for monitoring sine wave, single-phase AC voltage. This sensor requires an Input Cable to connect to the UX120-006M, ZW series and U series of data loggers.
Highlighted Features
- Available in 2 ranges: 0 to 150 & 0 to 300 Volts AC
- Requires an Input cable (part # CABLE-4-20mA)
In what environment does this sensor operate?
This sensor operates in an indoor environment.
What measurements does this sensor support?
The T-CON-ACT-xxx sensor supports the following measurement: AC Voltage
The country of origin for this product is Israel. To see the full specifications for this product, please see our product manual found under the documentation tab if available
- Ranges: 0-150 and 0-300 volts RMS
- Sensor accuracy: < ±0.1% of span (20% to 120% of range) ±0.25% of span (10% of range)
- Over range: +20% of span
- Over load: +40% of span
- Frequency: 60 Hz AC
- Supply: Self-powered
- Output: 0–20 mA
- Response time to 90%: <240 msec
- Operating conditions: -20° to 70°C (-4° to 158°F); 5-95% RH, non-condensing
- Housing: Plastic polycarbonate
- Protection Level
Box: According to IP-50 DIN 40050
Terminals: According to IP-10 DIN 40050 - Mounting: Standard 35mm DIN rail
Notes: Because these sensors tie directly into the line, they should be used only by qualified personnel.
Requirements
- For U12 & H8 Loggers: Input Cable (Part # CABLE-4-20mA)
- For HOBO Energy Logger: FlexSmart Analog Module (Part # S-FS-CVIA)
|
|
سجل معنا في القائمة البريدية ليصل اليك كافة المستجدات والعروض التي هي محل اهتمامك